RCModelScout.

Hobby-Lobby

SHOCKWAVE 36 RTR W/ T-DRIVE (OVERSIZE)

Needed to complete: Fuel (quart), 500cc Fuel Bottle or Fast Tap Quart Bottle Spout, Glow Plug Wrench, 7.2v Battery and charger, Ni-Cd Glow Driver, 12 AA alkaline batteries (8 for the transmitter and 4 for the receiver), Clear tape to seal radio box Tech Notes: To increase speed on calm water, bend the trim tabs up 1/4 to 1/2 inch with a pair of pliers. This will lift the front of the hull out of the water at high speeds, lower hull resistance and increase speed. This may, however, lessen the cornering ability. The trim tabs can also be adjusted individually to level the boat and compensate for engine and propeller torque. You can also increase top speed by removing the anti-skid fins, but you may experience reduced stability in rough conditions. Technical Specifications: ShockWave 36 RTR w/T-Drive Specs:Length: 36 in., ,

Hobby-Lobby

ULTRACOTE GREEN

Temp ranges are as follows:, Adhesion to wood begins at 200 to 220 degrees F., Key Features:, High tech polyester covering, Temp ranges are as follows:, Adhesion to wood begins at 200 to 220 degrees F., Surface Preparation:, The covering job can only be as good as the finish of the surface it's applied over. In order for the covering to properly adhere to a surface, the surface must first be smooth and clean. Sand the model using a sanding block and progressively finer sandpaper, with the final sanding being done with 320 grit paper. Vacuum away all of the dust, as specks of dust under the covering will leave unsightly bumps. Fill gaps and dents with a high-quality filler. If using light-colored UltraCote (such as white or yellow), use a tan-colored filler that matches the wood color to prevent the filler from showing through., Trim Film to Size:, Start by covering the bottom of one wing half. Using scissors or sharp hobby knife, cut a piece of UltraCote a few inches larger than needed to cover the wing. Remove the backing (save for later) and place the covering with the adhesive (dull) side down, centered over the wing. Set the covering iron to the application temperature of 220�F., Tacking Covering to Spar:, Tack the covering to the spar or the high point of the wing, using your iron as shown (an iron sock is highly recommened). Gently pull the covering toward the root and toward the tip, as you work the iron from the center of the spar to the root and tip of the wing. Press gently with the iron, allowing the heat (not pressure) to activate the adhesive and bond the covering to the high point. Ideally, the covering will naturally lay flat against the entire surface with a minimum of wrinkles., Covering a Solid-Sheeted Wing:, If covering a solid-sheeted wing, work from the center of the spar outward to the trailing edge and then to the leading edge as shown, using the iron at 220�F. If a wrinkle develops, the covering can be carefully lifted and reapplied., Covering an Open-Structure Wing:, If covering an open-structure wing, ,

Hobby-Lobby

MP80G BRUSHLESS ULTRA SPEED TAIL ROTOR SX 4.8V

MP80G Brushless Ultra Speed Tail Rotor Sx 4.8V Highlights:, Brushless motor for the highest resolution possible, Tech Notes:, Technical Specifications:, MP80G Brushless Ultra Speed Tail Rotor Sx 4.8V Specs:, Application:, .50 to .90-size heli tail rotor gyro servo, Speed:, .05 sec/60-degrees @4.8V, Dimensions (WxLxH):, .83 x 1.59 x 1.57 in, Connector Type:JR, Deadband:, Zero deadband for ultra precision and performance,

Hobby-Lobby

3200MAH 6S 22.2V 30C LIPO BATTERY

Technical Specifications:,

Hobby-Lobby

3200MAH 3S 11.1V 20C LIPO BATTERY

Technical Specifications:, 20C 11.1V 3200mAh 3S LiPo Tech Notes:, Min Discharge Volts Per Pack: 9V,

Hobby-Lobby

3600MAH 4S 14.8V 25C LIPO BATTERY

Technical Specifications:,

Hobby-Lobby

1320MAH 3S 11.1V 13C LIPO BATTERY

13C 11.1V 1320mAh 3S LiPo Tech Notes:, Min Discharge Volts Per Pack: 6V, Technical Specifications:, 13C 11.1V 1320mAh 3S LiPo Tech Notes:, Min Discharge Volts Per Pack: 6V,

Hobby-Lobby

MINI SUPER CUB RTF

Jason Says:, "I used the mini Super Cub to train one of my neighbors last year. The anti-crash tech really does work as advertised.", 31-3/4" wingspan, 21-1/2" long, 7 oz. flying weight. Anyone can have a good time flying the Mini Super Cub RTF. With Anti-Crash Technology, teaching yourself to fly has never been easier. Mini Super Cub comes right out of the box with everything you need included. Its durable Z-Foam construction makes the Mini Super Cub incredibly strong and easy to repair, and its unique trim scheme makes it look great in the sky and in your hands. Features: Anti-Crash Technology, Proportional 3-channel FM transmitter with 1300-foot range, 2 cell 7.4V 300 mAh Li-Po battery with 2 cell DC Li-Po charger and AC adapter, Durable and lightweight Z-Foam constructed fuselage makes repairs easy, Geared and brushed 180 motor allows for fast climbs and exciting maneuvers, One-piece wing with factory-applied decals, Mini Super Cub "Learn to Fly" DVD with assembly instructions., Technical Specifications:, Length:, 21-1/2", Wingspan:, 31-3/4", Flying Weight:, 7 oz., Controls:, Elevator, Rudder, Throttle,

Hobby-Lobby

SENIOR TELEMASTER LASER CUT KIT

Jason Says:, "Simply the best design I've seen! No more hassle to get the wings on and off, amazing. ", The Senior Telemaster Kit includes a drop box: a large hatch on the bottom of the fuselage can be remotely opened by a servo for candy drops or parachute drops. The fuselage interior is large with lots of room for a camera. When the drop door is opened it swings to the rear and is held open by magnets., Kit includes strong aluminum landing gear and bent wire tailwheel assembly, pushrods and clevises. Axels, main wheels and tail wheel not included. You will need 4 rolls of covering. A 6-channel radio system is required to use all functions: Ailerons (2 servos), Flaps (2 servos), Elevator, Rudder (2 HS-225 servos), Drop hatch (eRC 9g servo)., What's New in the Senior Telemaster V2 Kit:, All laser cut precision balsa and plywood, Building Videos:,

Hobby-Lobby

MP80G BRUSHLESS ULTRA SPEED TAIL ROTOR SX 4.8V

MP80G Brushless Ultra Speed Tail Rotor Sx 4.8V Highlights:, Brushless motor for the highest resolution possible, Tech Notes:, Technical Specifications:, MP80G Brushless Ultra Speed Tail Rotor Sx 4.8V Specs:, Application:, .50 to .90-size heli tail rotor gyro servo, Speed:, .05 sec/60-degrees @4.8V, Dimensions (WxLxH):, .83 x 1.59 x 1.57 in, Connector Type:JR, Deadband:, Zero deadband for ultra precision and performance,

Hobby-Lobby

MONARCH KIT SKILL LEVEL 1 (HAZMAT)

Hobby-Lobby

HYPER BAT

Hobby-Lobby

MINI SUPER CUB RTF

Jason Says:, "I used the mini Super Cub to train one of my neighbors last year. The anti-crash tech really does work as advertised.", 31-3/4" wingspan, 21-1/2" long, 7 oz. flying weight. Anyone can have a good time flying the Mini Super Cub RTF. With Anti-Crash Technology, teaching yourself to fly has never been easier. Mini Super Cub comes right out of the box with everything you need included. Its durable Z-Foam construction makes the Mini Super Cub incredibly strong and easy to repair, and its unique trim scheme makes it look great in the sky and in your hands. Features: Anti-Crash Technology, Proportional 3-channel FM transmitter with 1300-foot range, 2 cell 7.4V 300 mAh Li-Po battery with 2 cell DC Li-Po charger and AC adapter, Durable and lightweight Z-Foam constructed fuselage makes repairs easy, Geared and brushed 180 motor allows for fast climbs and exciting maneuvers, One-piece wing with factory-applied decals, Mini Super Cub "Learn to Fly" DVD with assembly instructions., Technical Specifications:, Length:, 21-1/2", Wingspan:, 31-3/4", Flying Weight:, 7 oz., Controls:, Elevator, Rudder, Throttle,

Hobby-Lobby

MINI SUPER CUB RTF

Jason Says:, "I used the mini Super Cub to train one of my neighbors last year. The anti-crash tech really does work as advertised.", 31-3/4" wingspan, 21-1/2" long, 7 oz. flying weight. Anyone can have a good time flying the Mini Super Cub RTF. With Anti-Crash Technology, teaching yourself to fly has never been easier. Mini Super Cub comes right out of the box with everything you need included. Its durable Z-Foam construction makes the Mini Super Cub incredibly strong and easy to repair, and its unique trim scheme makes it look great in the sky and in your hands. Features: Anti-Crash Technology, Proportional 3-channel FM transmitter with 1300-foot range, 2 cell 7.4V 300 mAh Li-Po battery with 2 cell DC Li-Po charger and AC adapter, Durable and lightweight Z-Foam constructed fuselage makes repairs easy, Geared and brushed 180 motor allows for fast climbs and exciting maneuvers, One-piece wing with factory-applied decals, Mini Super Cub "Learn to Fly" DVD with assembly instructions., Technical Specifications:, Length:, 21-1/2", Wingspan:, 31-3/4", Flying Weight:, 7 oz., Controls:, Elevator, Rudder, Throttle,

Hobby-Lobby

MINI SUPER CUB RTF

Jason Says:, "I used the mini Super Cub to train one of my neighbors last year. The anti-crash tech really does work as advertised.", 31-3/4" wingspan, 21-1/2" long, 7 oz. flying weight. Anyone can have a good time flying the Mini Super Cub RTF. With Anti-Crash Technology, teaching yourself to fly has never been easier. Mini Super Cub comes right out of the box with everything you need included. Its durable Z-Foam construction makes the Mini Super Cub incredibly strong and easy to repair, and its unique trim scheme makes it look great in the sky and in your hands. Features: Anti-Crash Technology, Proportional 3-channel FM transmitter with 1300-foot range, 2 cell 7.4V 300 mAh Li-Po battery with 2 cell DC Li-Po charger and AC adapter, Durable and lightweight Z-Foam constructed fuselage makes repairs easy, Geared and brushed 180 motor allows for fast climbs and exciting maneuvers, One-piece wing with factory-applied decals, Mini Super Cub "Learn to Fly" DVD with assembly instructions., Technical Specifications:, Length:, 21-1/2", Wingspan:, 31-3/4", Flying Weight:, 7 oz., Controls:, Elevator, Rudder, Throttle,